Fault fltIpv6AddrOperStDown
                

Rule ID:1615

Explanation:
This fault occurs when the operational state of the ipv6 address state is changed to subnet-overlap/no primary/addr already confgd as next hop in a static route/interface address count limit exceeded. This can also happen if BD is not getting programmed in the node/switch when number of vlan address space in the node/switch is exceeded

Recommended Action:
To recover from this fault, try the following actions

1. Look at any configuration issues
2. Verify the configuration is correct/complete
3. Check if the vlans per node/switch is not exceeded than the advertised limit either through capacity dashboard or through the command "show vlan summary" for the field "Number of existing VLANs" at the node/switch where the fault is generated
4. Check if the number of addresses configured for the interface do not exceed the advertised limit (512)

Fault Name: fltIpv6AddrOperStDown

Unqualified API Name: operStDown
Code: F1615
Applied Mo DN Format:
     topology/pod-[id]/node-[id]/sys/ipv6/inst/dom-[name]/if-[id]/addr-[addr]
     sys/ipv6/inst/dom-[name]/if-[id]/addr-[addr]

Type: operational
Cause: ip-provisioning-failed
Severity: major
Weight: 100
Tags:
Message: IPv6 address(addr) is operationally down, reason:operStQual on node id fabric hostname name

Help:

Triggered By:
         operStQual not equals unspecified
        and
         operStQual not equals up