Cleaning Devices

For cleaning devices that are unlike each other (different os/platform/steps required) it is best to use the devices block inside the Clean Yaml. This block allows you to customize the clean on a per-device basis. The devices block is an optional block (although most commonly used).

Adding the Devices Block

In the Clean YAML that has the Cleaner Class added, add the devices block as shown below.

1cleaners:
2    PyatsDeviceClean:
3        module: genie.libs.clean
4        devices: []
5
6devices:

Adding a Device

Next, add the device to the Clean YAML in which we want to write a Clean for. This device must exist in your Testbed YAML and for the purposes of this guide, the device is named PE1.

1cleaners:
2    PyatsDeviceClean:
3        module: genie.libs.clean
4        devices: [PE1]
5
6devices:
7    PE1:

It is supported to add any amount of devices under the devices block. Below shows how to add another device named PE2.

1cleaners:
2    PyatsDeviceClean:
3        module: genie.libs.clean
4        devices: [PE1, PE2]
5
6devices:
7    PE1:
8
9    PE2:

Adding Stages

Note

In the event you do not know what a stage is, what it does, and what arguments they accept, you can find that information in the Intro to Stages document.

Below is an example of adding the connect stage under PE1 in the Clean YAML. This stage has a few arguments that are all optional. If in the case you are satisfied with the default values, you can leave the value side of the key-value pair empty as shown in the example.

The order key must also be defined, even if there is only one stage.

 1cleaners:
 2    PyatsDeviceClean:
 3        module: genie.libs.clean
 4        devices: [PE1, PE2]
 5
 6devices:
 7    PE1:
 8        connect:
 9
10        order:
11        - connect
12
13    PE2:

It is supported to add as many stages as needed. Below is an example of adding another stage called apply_configuration under PE1 in the Clean YAML. To pass any arguments for the stage, simply add it under the stage as shown in the example.

It will run after the connect stage as defined under the order key.

 1cleaners:
 2    PyatsDeviceClean:
 3        module: genie.libs.clean
 4        devices: [PE1, PE2]
 5
 6devices:
 7    PE1:
 8        connect:
 9
10        apply_configuration:
11            configuration: hostname PE1
12
13        order:
14        - connect
15        - apply_configuration
16
17    PE2: